ESC Control Panel
Telemetry & Control
Telemetry
| Value | 5sec Min | 5sec Max | |
|---|---|---|---|
| Voltage: | - V | - | - |
| Bus Current: | - A | - | - |
| Phase Current: | - A | - | - |
| Temp: | - °C | - | - |
| Motor Temp: | - °C | - | - |
| eRPM: | - | - | - |
| Input Duty: | - % | - | - |
| Motor Duty: | - % | - | - |
| Power: | - kW | - | - |
Protocol
Bi-directional
Telem Request
TX Hex
—
Throttle
0
Min %
Max %
Period ms
Waveform
Start Hz
End Hz
Duration s
Offset %
Amp %
Duration s
Throttle CSV
Interval ms
CSV format: one throttle value per line, 0–1000
(raw slider units) — 500 = OFF in bi-directional mode.
Each value is sent after the set interval. Header lines
and extra columns are ignored.
Arm Status
Node ID (this app)
CAN Bitrate
ESC Count
Command Rate
Telemetry Source
DNA Server
| Node | Name | Mode | ESC | RPM | V | A | °C | Age |
|---|
No DroneCAN nodes seen yet.
Arm Status broadcasts the arm signal some ESCs require
(throttle is always sent). Keep this tab visible while driving.
Offline
Session name
PIN
Allow remote control
Viewers open the ESC Remote Panel on this site and enter the PIN.
Remote control is off until you enable it; one viewer at a time may then
drive the throttle, drive modes and protocol settings. E-STOP (local or
remote) sets throttle to OFF and drops the current driver — remote
control stays enabled until you switch it off.
Telemetry Plot